Pony Tail Fleece Hat
For gals with a pony tail you have quite the dilemma when you need to pop on a hat to go outside. To avoid a big lump on the back of your head we will make up a Fleece Winter Hat that has an elasticized end that allows you to pull your high pony tail or your messy bun out the top.
The cozy scarf/snood shown in the photo below is just as easy to make….just follow this link.
Let’s Get Started!
You will have this hat sewn up in 15 minutes! This is a great first sewing project if you are new at this or if you have a youngster you would like to teach how to use the sewing machine.
View from the front!
Let’s take a moment to give a shout out to my hat model Miss B. She was cold…those eyes are smiling but also pleading to get back inside!
View from the back! It’s a little slouchy and super easy to pop your pony head out of the back.
You will need:
- Fleece fabric
- Elastic
- Safety Pin
- Sewing machine
- Scissors
- Thread
Fleece Fabric
Start by measuring your head and work out your size OR just go with the below suggestions. Fleece is a very forgiving fabric. If it’s too small it will stretch and if it’s a bit too big it will sit nicely on your head.
A young child size hat cut fabric to: 20 x 12 inches.
My 7 year old was 21 inches x 12 inches.
My 10 year old was 22 inches x 13 inches.
An adult size hat cut fabric to: 23 x 14 inches.
Hubby had a big head and he was 23 1/2 x 13 inches.
This hat is for my 10 year old so we measured and cut a piece of fleece 22 x 13 inches.
Fold the fleece in half with the right sides together.
Pin the side and sew using a ¼ inch seem allowance.
This is my 10 year old’s first time taking the sewing machine for a spin.
Fold over 1 inch on the bottom edge and pin. This will be the bottom edge of the hat.
Fold the bottom cuff over an inch and sew over the edge with a zig zag stitch.
Again pin the edge of the other end for the top part of the hat.
This time we did a straight stitch and stop sewing before you get an inch from where you started to sew. This will be our elastic casing.
You will need a small piece of thin elastic but do not cut it to size until later. Pin the end of the elastic and use the pin as a tool to wiggle the elastic through the casing.
Slide the pin into the one inch gap.
Wiggle the pin all the way around. I apologize for my cuticles in this photo!
Overlap the ends of the elastic and pin together.
Secure the elastics with a few stiches forward and backward.
Hand or machine stitch the one inch gap closed.
Now, flip the hat right side out…how does it fit?
Wonderful job!
Now heads will be cozy and pony tails will be free!
Put it on your gorgeous head! Now get outside!
—
Easy to Make Fleece Hat with Flowers – Simple Sewing Project
Sew a Super Easy Fleece Poncho-Simple Starter Sewing Project
Popcycle Stick Picture Frames -Easy Kids Crafts
What could be easier than this popcycle stick picture frame. Paint and decorate the popcycle sticks. Glue together to fit the photo you will use. Hot glue works quickly to attached the square of popcycle sticks. Hot glue a piece of ribbon on the back. OR strips of magnets if you would rather this be a fridge magnet.
You will need: wide popcycle sticks, glue or glue gun. Glitter glue, gems depending on how decretive you want to get-you could just let a toddler finger paint it.
Secure the photo in place with a few pieces of tape. Hang it up and enjoy!
I did this for all of my daycare children back when I ran a home daycare. I strung them all across a string that was fastened to 2 screws so it looks like a bit of a clothes line. It had a really sweet effect. The kids all worked on their own frame and when it was time for them to leave my care and become school kids they took it with them and a scrap book of art I had saved. Ohhh…sentimental pause….. I wonder how my little friends are growing up…..sniff sniff…
…
How to Sew an Easy Fleece HairBand
Anyone can make this!
This super cute hairband was made from a left over piece of fleece from a poncho project Fleece Poncho Top in photo found at this link: http://mybrightideasblog.com/?p=218&preview=true
Miss M and I made her first sewing project the fleece poncho and with a few more minutes sewed up the co-coordinating headband.
For a 7 year old head we cut 2 strips of fabric 5 inches by 20 inches. For an adult sized head cut 6 inches by 22 inches strips of fabric.
Fold each strip in half to lengthwise (right sides together) to form a tube and sew a seem.
Pull the end through the tube to turn it right side out.
Lay one strip on the bottom with seam facing up. The other lay on top with the seam facing down. Fold the bottom one in half.
Fold the top one in half. Pull the ends even. Now its starting to take shape. Try holding it in place to see how if fits.
I tucked the ends of the right side into the left side and folded under the edge so it wouldn’t have any raw edges showing. Sewing a line across all the layers is a little tricky. Fleece or jersey-t-shirt material can be used and is very forgiving for sizing. You could use this idea for re-purposing old clothes.
Sew a Super Easy Fleece Poncho-Simple Starter Sewing Project
This fleece poncho type body warmer will take the chill off! Its so simple my 7 year old Miss M. did the sewing!
First step. Measure the approximate width over the shoulders for where you would like it to sit. Then measure the body length from the shoulder to around the waist. This is the kind of not very specific measuring I find myself doing all the time. A fitted dress with darts and zippers is not my kind of sewing.
We decided to go 25 inches wide and 20 inches from the shoulder to waist hips area (so double that).
This means you will need to cut a piece of fleece 40 inches by 25 inches.
For the neck hole: find the middle and use a t-shirt to show how big the neck hole is and copy that onto the middle of the fleece. I like to fold the fleece in half so the neck will be easier to cut.
I went a bit bigger than the tshirt and wished I had gone a bit smaller instead. As long as it goes over the person’s head its great. If you make a cut that it too small you can try it on and then cut a bit more off.
You could leave all the seams unfinished if you would like because they won’t fray like cotton would. However, this was Miss M’s first time at the machine so we wanted some easy sewing. We folded the fabric over once and did a Zig Zag all around the straight edges.
Around the neck we folded over the fabric once and did a straight stitch.
Then we laid it out flat folded in half. We measured 7 inches from the shoulder and put a pin to mark it. Then 3 inches down add another pin. Sew between the 2 pins. We used a straight stitch-this part will be under the arms.
Miss M. pretended that it was a huge inconvenience to come over and take a few photos but she seems to have enjoyed herself.
The fancy hairband will be in this blog: http://mybrightideasblog.com/sew-easy-fleece-hairband/
Celery Flower Painting – Easy Kids Craft
Do you remember doing potato paintings when you were a kid? I sure do and this is a new spin on it CELERY PAINTING! It creates a fun, flowery sort of painting. This craft is so easy a toddler could do it…and it will actually look quite nice in on the fridge.
You will need paint, brushes, plain paper and celery cut off close to the bottom or if its another part of the bunch of celery put an elastic around it so it doesn’t all apart.
Start out by brushing some green flower stems onto the paper.
Paint the flat ends of the celery with your brush to make sure every end gets covered with a light coat of paint for a lighter effect like the yellow and pink roses above.
For a more defined flower use a sponge brush and a lot of paint and push hard on your celery to really put the imprint on. I pulled off two of the outer celery stalks and tried to make some rose buds also.
With a bit of help your toddler could have a lot of fun with this. An older child cold make something quite pretty for a gift to take to grandma’s house….you could even put some sparkle glue in the flowers after the paint has dried.
Beaded SnowFlake Suncatcher-Easy Craft for Kids!
We love Beads and Pipe-cleaners are a craft cupboard essential. So on this snowy winter’s day the kids and I made snow flakes to hang in our windows-and we used just those 2 ingredients. Beads and Pipe-Cleaners! Sparkly beads look so lovely in the window-so this will make a gorgeous sun-catcher.
Cut a 3 pipe-cleaners in half. I think the sparkly style would have looked gorgeous but today we only found turquoise and white which both give a nice cool look.
Take the 3 half length pipe-cleaners and twist in the middle so they hold the shape of a snowflake.
String on plastic beads. As long as the bead hole is big enough to slide a pipe-cleaner through it will work. But if your crafter is younger you may want to use pony beads-the type of plastic bead with big holes.
We chose white, clear, silver, turquoise and blue. As you get close to the end bend the pipe-cleaner so that the beads don’t slide off.
Find a scrap of narrow ribbon to tie to an end and hang from the window. Stand back and admire!
….
My First DIY Project-Door Window Insert
Renew your ugly old door with a window insert and a fresh coat of paint and door handle.
My first home improvement project involving proper tools was to change the window on the front door. Our home was built in the 1950’s and although this door wasn’t the original it was ugly-with a sort of half moon towards the top and didn’t shed light in the front of the house.
At the time I had a home daycare and families were coming to the front door every day several times and the noisy munchkins often made it difficult to tell if someone had knocked and was waiting at the front door. I was constantly running to the front room and peering out the windows to see if anyone was there…and usually there wasn’t.
I went to Home Depot to see what a new door would cost me. It was not too bad but add on the installation costs-eek! I had the side door replaced so I know from watching that done it was well out of my skill level. The staff asked if it was a decent quality door…if yes it might just need an update with an insert. Say what?!?!
https://www.homedepot.ca/en/home/p.pergola-22-inch-x-36-inch-iron-glass-insert.1000784903.html
https://www.homedepot.ca/en/home/p.pergola-22-inch-x-36-inch-iron-glass-insert.1000784903.html
https://www.homedepot.ca/en/home/search.html?q=door%20insert&page=0
This will be helpful to know if you have a newish door but its the plain standard look. You can upgrade to ones with blinds between the panes of glass, or a window with a screen for a breeze or like me, a decretive pane to let the light in.
It was very hard to find how exactly to install the insert. I copied a blog I found about adding a dog door insert. I drew the cutting lines where I wanted the window to go by tracing the cardboard that comes with the insert. Then I got my largest drill bit and drilled a hole through the metal door an inch inside my cutting line. The drilled hole (or holes if you drill a few next to each other) is big enough to get a jigsaw blade in. Then start cutting lines through the door until you are able to cut out the entire rectangle of the insert.
A few reminders…jig saws have speed gauges which I didn’t realize until after the project was done. It was pretty fast and I could easily have cut the door right in half. It was literally my first time using a jig saw and I should probably have tested it out on something else first!
Move your small children far away and don’t be put off by their fears that their mom is about to ruin the front door.
And of course wear safety glasses. Now find a hubby to help you carry that heavy door back to the front of the house and pop the pins back in the hinges.
The insert literally just pops in and is secured by some push in plugs and your done! So easy and what an improvement. The inserts range from about $90 to $500 depending if you like fancy stained glass. There are really nice choices in the lower range too. I think mine was around $150.
Shortly after we painted the front of the door black and put on a gorgeous handle and had a front door to be proud of!
Charging Station-Where to put tablets, phones, cables?
How to organize your electronics and create a charging station so the cords are all in one place. Also, how do we put limits on how much screen time the kids have….and does anyone know what they are watching….and when….
A new problem for this generation is the numerous technology we have scattered around the house. We have several tablets, a Kobo e-reader and my hubby and I have our cell phones. Finding a cord to match was getting frustrating. Someone would unplug it and move it to their bedroom or the kitchen to keep using it even though the low battery signal has popped up. Well fear not! I have the solution.
I went to the store Solutions and was not able to find an actual charging station. I did find a lot of things that could be used to tidy up the devices and give them a place to tuck in at night.
http://www.solutions-stores.ca/kitchen/
This is a simple Kitchen Organizer meant for pot lids. You can find it in a houseware department in a variety of stores.
The next question is should they have the screens in the bedroom? My kids are still rather young not to be supervised. If they were watching a Meghan Trainer video or you tube https://www.youtube.com/watch?v=pkCyfBibIbI(instant kitchen dance party) I would want to be able to see if another video pops up-since music videos come in all varieties.
Should we put a limit on screen time? Homework must be done of course. Is 2 hours too much? Too little? Have they spent enough time interacting with family members before they dive into an episode of Fuller House? Its very hard to pull them away after they get into a show or two. If we say yes to one episode…can I get a pinky promise you will actually turn it off?
Technology is really becoming a problem. Games are becoming a rising concern as an addiction. Cyber bullying is so detrimental to everyone involved. There is so much to think about and personal decisions we need to make to keep our kids safe and cyber-smart.
A good first step is getting the gadgets back to my charging station by 8pm for recharging. Let me know in the blog comments if you have any suggestions on how to keep the technology in your family with a healthy balance. I’d love to hear your suggestions.